Doug T.
Lifetime Member
Pettin' The Gator
Posts: 1,199
|
Post by Doug T. on Sept 5, 2011 15:53:19 GMT -5
Hi All! I was kind of stumped as to how to proceed with my Oly. The best way, I suppose, is to just do it I found that small pieces of double sided sticky tape worked fine for the mirror. It didn't work on the back. Contact cement might be a better choice. Here the back I thought that I'd better get some photos posted before I clean it up. I'm not too crazy about the lens, but it will have to do until I find a better one. I think I got a pretty good deal for my 5 bucks, and it came with a polarizing filter as well Doug
|
|
mickeyobe
Lifetime Member
Resident President
Posts: 7,280
|
Post by mickeyobe on Sept 5, 2011 18:40:08 GMT -5
Doug,
If you use contact cement try not to completely remove the back covering. It is much easier to position it if part is still attached. Contact cement does not allow for repositioning.
Mickey
|
|
Doug T.
Lifetime Member
Pettin' The Gator
Posts: 1,199
|
Post by Doug T. on Sept 6, 2011 10:29:10 GMT -5
Mickey, Thanks for the tip Luckily the back is still about half stuck on, so I shouldn't run into too much trouble getting it back in place. I'm heading into town to see if I can find some spray-on sticky stuff. Doug
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Sept 6, 2011 18:16:16 GMT -5
Pliobond for gluing covering. It a rubber-type cement. For permanency apply to both surfaces allow to dry until tacky, the press two surfaces together.
|
|