matty
Lifetime Member
Posts: 126
|
Post by matty on Apr 28, 2013 4:04:42 GMT -5
Hello Everybody, I've had an OM20 sat on the shelf for a little while needing new lightseals and just wanted to check something before I started on it. There has been a bit of botched work done on it, a very, bad seal replacement at the hinge end of the door, so I'm not too sure on what has been taken out. I'll replace the hinge seal, and in the channels along the edge but does the OM20 have any seal at the catch end of the door? This is the bit I'm not sure about. Thanks Matty
|
|
Stephen
Lifetime Member
Still collecting.......
Posts: 2,718
|
Post by Stephen on Apr 28, 2013 6:34:35 GMT -5
I'll get an old body OM I0 have aside, to check the seals positions on later this afternoon. The body is the OM 10, but it shares the same body and door, more or less.
Stephen
|
|
lloydy
Lifetime Member
Posts: 506
|
Post by lloydy on May 13, 2013 17:58:11 GMT -5
OM 30 - no seal on the catch end, OM 1, there's a film in it.
|
|
matty
Lifetime Member
Posts: 126
|
Post by matty on May 14, 2013 16:39:07 GMT -5
Thanks Lloydy, I'll run with that. As far as I can tell all the "consumer" grade OMs have similar bodies. Matty
|
|